123,123

建筑幕墻英語（五）
	發起人：eging4　　回復數：1　　瀏覽數：6768　　最后更新：2022/9/28 3:49:00 by nihaota

發表新帖

　帖子排序：

eging4 發表于 2017/5/17 10:47:44

回復編輯刪除

建筑幕墻英語（五）

1/2" Φ bolt 6" long with washer, lock nut and pipe sleeve field match drill steel angle and alum. Plate

直徑1 / 2英寸,長度6英寸的螺栓, 墊片, 自鎖螺母和套管. 現場對正角鋼和鋁板鉆孔

1/2" Φ bolt 6" long with washer and lock nut field match drill steel angle and steel anchor

直徑1 / 2英寸,長度6英寸螺栓, 墊片, 自鎖螺母. 現場對正角鋼和錨固板鉆孔

(2) 1 / 2" Φ X 6" bolts w/ flat washer, lock washer and nut field match drill mullion

(2) 1 / 2" Φ X 6" 英寸螺栓,平墊圈,防松墊圈,螺母, 現場立柱鉆孔對正

1 1/2" x 1 1/2" alum. angle 8" lg 24" o.c. 1 1/2" x 1 1/2" 英寸角鋁, 8英寸長, 24英寸中心

1 / 2" Φ X 2" bolts w/ flat washer, lock washer and nut and slip shims field match drill mullion and steel bearing plate

1 / 2" Φ X 2" 英寸螺栓,平墊圈,防松墊圈,螺母和隔離墊片,現場在立柱和支承鋼板上對正鉆孔

25000MM radius wall 25000MM 半徑圓弧墻面

28700MM radius wall

28700MM 半徑圓弧墻面

3MM alum. pipe sleeve 3mm 鋁套管

32050MM radius wall 32050MM半徑圓弧墻面

5" x 5 1/4" x 1/8" thk. alum. Plate

5" x 5 1/4" x 1/8" 英寸鋁板

50-55 durometer shore a neoptene side blocks locate at upper quadrant of each shallow pocket jamb

氯丁橡膠側墊塊，邵氏硬度a50-55，位于每個淺槽邊框上端四分之一點。

50-55 durometer shore a neoptene " w " side blocks locate at upper quadrant of each deep pocket jamb

氯丁橡膠"w"形測墊塊，邵氏硬度a50-55，位于每個深槽邊框上端四分之一點。

65.0MM to face of slab 距樓板表面65.0MM

7900MM radius wall 7900MM 半徑圓弧墻面

7900 wall elevation 7900MM半徑圓弧立面圖

80-90 durometer shore a neoprene setting blocks 150MM lonng at quarter pts

氯丁橡膠墊塊,邵氏硬度a80-90，長度150MM，位于兩端四分之一點。

8" alum. splice sleeve center between mullions 8英寸鋁套管,插入兩立柱等長

9MM weep holes at quater pts. 9MM 排水孔，位于兩端四分之一處

9/16" x 3" slot in alum. plate and steel bar

在鋁板和鋼板上切9/16" x 3" 英寸槽口

alum. panel soffit by others 其他方負責挑檐鋁板封修

alum. splice sleeve at mullion joint 立柱交接處鋁套管

anchor bolt 錨固螺栓

anchor bolt connection 錨固螺栓連接

at splice 立柱拼接處

approx. 大約

continuous silicone perimeter seal

幕墻交界處周邊連續硅膠密封

continuous silicone seal 連續硅膠密封

door and subframe by other 其他方負責門及其邊框

expension horizontal 水平伸縮縫

fix fasten splice sleeve to lower mullion

將套管與下立柱固連在一起

high impact polystyrene shim

高耐沖擊聚苯乙烯墊片

interior silicone perimeter seal 室內周邊硅膠密封

notch stem of mullion at butt joint glaxed spandrel area

窗間墻玻璃對接縫處, 切掉立柱突出部分

note: 28MM insulated vision glass will be needed on floors 34 - 38 on the 6900 all (high wind load regions) w

注意: 在34~38層半徑為6900MM墻面, 中空玻璃的厚度為28MM.

paneling byothers 其他方負責封板

primary continuous perimeter silicone seal

第一道連續周邊硅膠密封

provide bond breaker tape at splice sleeve at sealed joint

膠縫處在套管上加貼隔離膠帶

seal flashing to face of slab 泛水板與樓板面密封

set in sealant= 填塞密封膠

shim as required 按要求加墊片

silicone perimeter seal 周邊交界處硅膠密封

steel reininforce section 鋼件加強剖面圖

surround by others 由其他方封口

surroundings by others 由其他方封口

splice sleeve 立柱拼接套

splice plate with bond breaker tape and sealant at joints in closure

拼接墊板與膠縫用隔離膠帶隔開

silicone sealant w/ rod 硅膠及后置填充棒

structural silicone and no

rton v2100 glazing tape 結構膠和

norton v2100 玻璃裝配膠帶

trim cover below 下方飾蓋

typ. 26mm infill jamb 標準26MM玻璃幕墻邊框垂直節點

typical canteler anchoring 標準懸臂錨固支架

IP：116.226.152.213　快速回復

nihaota 發表于 2022/9/28 3:49:02

回復編輯刪除

討債公司/藍月傳奇輔助/藍月輔助

IP：117.143.134.158　快速回復

管理：　　